Q&A Forums
Brush Wear Maintenance Post New Topic | Post Reply
| Author | Comments |
|---|---|
|
erik williams
Posted: Dec 15, 2008 08:19 PM
|
Brush Wear Maintenance
I have a Graco E30 that recently displayed code e29 (brush wear maintenance).Is this a minor maintenance item or could it turn into a big deal...?? I haven't noticed any difference in operation, it is about 3.5 years old and has sprayed about 30 to 40 sets. I'm also interested in hearing from anyone with a machine other than Graco... Also, was this maintenance completed at a standard repair facility or other? Thanks. |
|
JR Burnett
Posted: Dec 16, 2008 07:39 AM
|
Give me a call at 706-818-1942 , I can walk you through any problem, or answer any questionsn you may have over the phone.. JR |
|
Bubba Pallo
Posted: Jan 28, 2009 08:02 PM
|
It's not a difficult repair. The hardest part is removing the "A" side pump pin so you can seat the brushes after installation (this is a must, don't skip this step). Follow the manual step by step and you should have no problems. A good tip is to remove the fan shroud so you can get to the bottom brush. It's only 4 screws and it comes right off. |
