Any hope? | Homeowner's Questions About Using Foam | Spray Foam Technical Questions and Answers | SprayFoam Magazine Q&A Forums

Q&A Forums

Author	Comments
Patrick Ramp Posted: Jan 23, 2014 03:29 PM	Any hope? I have LOTS of spray foam cans (like 25) that have been left out in the barn and froze. Is there any hope in saving them? I was hoping to warm them up in water SLOWLY. They are also expired. I know I will not get 100% output, but I am hoping for something
Posted: Jan 28, 2014 02:59 PM	Of course you can try, but you probably won't have the best of luck. You are right in the loss on yield for sure. The best thing is to just make sure you have a very warm, dry, and clean surface you are spraying onto. I would also spray a small area and wait a good 24 to 48 hours to see if there is any shrinkage and separation from the applied surface as well. Good luck!

Author

Comments

Patrick Ramp

Posted: Jan 23, 2014 03:29 PM

Any hope?

I have LOTS of spray foam cans (like 25) that have been left out in the barn and froze. Is there any hope in saving them? I was hoping to warm them up in water SLOWLY. They are also expired. I know I will not get 100% output, but I am hoping for something

Posted: Jan 28, 2014 02:59 PM

Of course you can try, but you probably won't have the best of luck. You are right in the loss on yield for sure. The best thing is to just make sure you have a very warm, dry, and clean surface you are spraying onto.

I would also spray a small area and wait a good 24 to 48 hours to see if there is any shrinkage and separation from the applied surface as well. Good luck!

You need to login to reply to this topic. Please click here to login.