H20-35 pro Temp Controller | Equipment Q&A | Spray Foam Technical Questions and Answers | SprayFoam Magazine Q&A Forums

Q&A Forums

Author	Comments
Posted: Jun 02, 2008 06:20 AM	H20-35 pro Temp Controller All three of my temp controllers have the plastic face's broken off. They have used a cheap face, and when they break I am told that you need to replace the entire unit. Right now we are useing the yellow plastic to push into the holes to change the temp. Nothing wrong with the rest of the unit. Seems like we should be able to replace the face on these units. Anybody else having the same problem. jp
SPRAYFOAM GODDESS Posted: Jun 05, 2008 02:54 PM	Those "face plates" are referred to as the bezel, Graco does not offer those replacement parts, as you have found out, Gusmer used to. I have heard you can look at the manufacturer on the back of those units and get them direct, not sure if this is true, but worth a shot.

Author

Comments

Posted: Jun 02, 2008 06:20 AM

H20-35 pro Temp Controller

All three of my temp controllers have the plastic face's broken off. They have used a cheap face, and when they break I am told that you need to replace the entire unit. Right now we are useing the yellow plastic to push into the holes to change the temp. Nothing wrong with the rest of the unit.
Seems like we should be able to replace the face on these units.
Anybody else having the same problem.

jp

SPRAYFOAM GODDESS

Posted: Jun 05, 2008 02:54 PM

Those "face plates" are referred to as the bezel, Graco does not offer those replacement parts, as you have found out, Gusmer used to. I have heard you can look at the manufacturer on the back of those units and get them direct, not sure if this is true, but worth a shot.

You need to login to reply to this topic. Please click here to login.