Low Output Tips and Guns. | Equipment Q&A | Spray Foam Technical Questions and Answers | SprayFoam Magazine Q&A Forums

Q&A Forums

Author	Comments
Steve Law Posted: May 15, 2008 01:49 AM	Low Output Tips and Guns. I am pricing up a job for a prefab wall manufacturer. I need to spray 2lb closed cell into 6 inch wide cavities at 1 inch thick. I use a Graco AP Fusion and am needing advice on tip selection. I would consider a different gun if I had to.... any thoughts? PS. I need to be quite close as there are metal braces at 6 inch centers that need to be kept as clean as possible. Cheers
Gerry Wagoner Posted: May 17, 2008 09:04 AM	Might try a Pentech palm gun. regards, oG

Author

Comments

Steve Law

Posted: May 15, 2008 01:49 AM

Low Output Tips and Guns.

I am pricing up a job for a prefab wall manufacturer. I need to spray 2lb closed cell into 6 inch wide cavities at 1 inch thick. I use a Graco AP Fusion and am needing advice on tip selection. I would consider a different gun if I had to.... any thoughts?

PS. I need to be quite close as there are metal braces at 6 inch centers that need to be kept as clean as possible.

Cheers

Gerry Wagoner

Posted: May 17, 2008 09:04 AM

Might try a Pentech palm gun.

regards,

oG

You need to login to reply to this topic. Please click here to login.